Configuring A Ce1/Pri Interface To Work In E1 Mode - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Interface Management
No.
2
To configure a CE1/PRI interface to work in CE1/PRI mode, you need the following data.
No.
1
2
3

6.4.2 Configuring a CE1/PRI Interface to Work in E1 Mode

This section describes how to configure a CE1/PRI interface to work in E1 mode and how to set
parameters for the CE1/PRI interface.
Context
If a CE1/PRI interface works in CE1/PRI mode and has timeslots bundled, delete the timeslot
bundling configuration. Otherwise, the CE1/PRI interface cannot be configured to work in E1
mode.
All parameters except the clock mode of CE1/PRI interfaces on both ends must be the same.
Otherwise, errors may occur during communication.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
controller e1 interface-number
The specified CE1/PRI interface view is displayed.
Issue 01 (2012-04-20)
Data
Optional parameters of the CE1/PRI interface, including the description, clock
mode, line idle code, interframe filling tag, minimum number of interframe filling
tags, and AIS detection
Data
Number of the CE1/PRI interface to be configured
l Number of the channel set and numbers of the timeslots to be bundled to form
the channel set if a CE1/PRI interface needs to work in CE1 mode
l Numbers of the timeslots to be bundled to form a PRI set if a CE1/PRI
interface needs to work in PRI mode
Optional parameters of the CE1/PRI interface, including the description, clock
mode, frame format, line idle code, interframe filling tag, minimum number of
interframe filling tags, AIS detection, and RAI detection
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 CE1/PRI Interface Configuration
55