Setting The Snr On A G.shdsl Interface - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Interface Management
----End

14.4.7 Setting the SNR on a G.SHDSL Interface

You can set the SNR for a G.SHDSL interface to manage the AR1200.
Prerequisites
The G.SHDSL interface has been deactivated.
Context
The AR1200 supports the following SNR settings:
l
l
Procedure
l
Issue 01 (2012-04-20)
2. Run:
interface atm interface-number
The view of the G.SHDSL interface working in ATM mode is displayed.
3. Run:
shdsl capability g-shdsl
A capability is configured.
4. Run:
shdsl pam 16
The modulation mode is configured.
5. Run:
shdsl bind m-pair 2 pairs enhanced
A binding mode is configured.
NOTE
The shdsl bind m-pair 2 pairs command can only be configured on an interface in slot 0 or slot 2.
6. Run:
shdsl rate miaximum miaximum
The maximum rate of a G.SHDSL interface is set.
When the g-shdsl mode is used, the value ranges from 192 to 2304, in kbit/s.
7. Run:
shdsl rate minimum minimum
The minimum rate of a G.SHDSL interface is set.
When the g-shdsl mode is used, the value ranges from 192 to 2304, in kbit/s.
Uplink and downlink SNRs: When the actual SNR of the AR1200 is greater than the
configured SNR, the AR1200 is activated successfully.
Lowest uplink and downlink SNRs: When the actual lowest SNR of the AR1200 is smaller
than the configured lowest SNR, the AR1200 is disconnected.
Set the uplink and downlink SNRs on a G.SHDSL interface.
1. Run:
system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 G.SHDSL Interface Configuration
144