Checking The Configuration - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Interface Management
The system view is displayed.
Step 2 Run:
interface { ethernet | gigabitethernet } interface-number
The Ethernet interface view is displayed.
Step 3 Run:
flow-control
Flow control is enabled on the Ethernet interface.
By default, flow control is disabled on an Ethernet interface.
----End

3.5.2 Checking the Configuration

After Ethernet interface attributes are configured, you can check the configuration.
Prerequisites
The configurations of Ethernet interface parameters are complete.
Procedure
Step 1 Run the display interface [ interface-type [ interface-number ] ] command to check the
configuration of an Ethernet interface.
----End
Example
Run the display interface [ interface-type [ interface-number ] ] command to check the
configuration of an Ethernet interface.
<Huawei> display interface ethernet 0/0/0
Ethernet0/0/0 current state : UP
Line protocol current state : UP
Description:HUAWEI, AR Series, Ethernet0/0/0 Interface
Switch Port, PVID :
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-2000-0083
Last physical up time
Last physical down time : 2010-07-20 01:06:25
Current system time: 2010-07-21 16:07:53-05:13
Port Mode: COMMON COPPER
Speed :
Duplex: FULL,
Mdi
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input peak rate 0 bits/sec,Record time: -
Output peak rate 0 bits/sec,Record time: -
Input:
Unicast:
Broadcast:
Discard:
CRC:
Jabbers:
Runts:
Issue 01 (2012-04-20)
1, TPID : 8100(Hex), The Maximum Frame Length is 1628
: 2010-07-21 15:35:37
100, Loopback: NONE
Negotiation: ENABLE
: AUTO
126 packets, 34204 bytes
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
0, Multicast:
74, Jumbo:
0, Total Error:
0, Giants:
0, Throttles:
0, Alignments:
3 Ethernet Interface Configuration
52
0
0
0
0
0
26