Configuring The Outbound And Inbound Bandwidth Utilization Of An Ethernet Interface; Configuring The Network Cable Type For An Ethernet Interface - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Interface Management
----End
3.3.6 Configuring the Outbound and Inbound Bandwidth
Utilization of an Ethernet interface
After the bandwidth usage is configured for the incoming and outgoing traffic on an Ethernet
interface, the system sends a trap to the NMS when the actual bandwidth usage exceeds the
upper threshold. When the bandwidth usage falls below the upper threshold, the system sends
a clear alarm to the NMS.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent trap enable
The outbound and inbound bandwidth utilization alarm function is enabled on all Ethernet
interfaces.
Step 3 Run:
interface { ethernet | gigabitethernet } interface-number
The Ethernet interface view is displayed.
Step 4 Run:
trap-threshold { input-rate | output-rate } bandwidth-in-use [ resume-rate
bandwidth-in-use ]
The threshold of the outbound or inbound bandwidth utilization is configured on the Ethernet
interface.
By default, the threshold of the outbound and inbound bandwidth utilization is 100%.
----End

3.3.7 Configuring the Network Cable Type for an Ethernet Interface

You can configure the network cable type for an Ethernet interface to ensure that the interface
adapts to the actual network cable type.
Issue 01 (2012-04-20)
undo negotiation auto
The Ethernet interface works in non-auto negotiation mode.
4. Run:
speed { 10 | 100 | 1000 }
The rate is set for the Ethernet interface.
In non-auto negotiation mode, an Ethernet interface works at the maximum rate by
default. The rate of an FE interface cannot be set to 1000 Mbit/s.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Ethernet Interface Configuration
21