Huawei AR1200 series Configuration Manual page 114

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Interface Management
Pre-configuration Tasks
Before configuring an ISDN BRI interface, complete the following task:
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface bri interface-number
The ISDN BRI interface view is displayed.
Step 3 (Optional) Run:
mtu mtu
The MTU of the ISDN BRI interface is set.
By default, the MTU of an ISDN BRI interface is 1500 bytes.
Step 4 (Optional) Run:
description interface-description
A description is configured for the ISDN BRI interface.
Step 5 (Optional) Run either of the following commands to configure a link layer protocol for the ISDN
BRI interface:
l Run:
l Run:
By default, the link layer protocol of an ISDN BRI interface is PPP.
----End
Checking the Configuration
Run the display interface bri [ interface-number ] command to check the running status and
statistics of the specified ISDN BRI interface.
<Huawei> display interface bri 1/0/0
Bri1/0/0 current state : UP
Line protocol current state : UP (spoofing)
Description:HUAWEI, AR Series, Bri1/0/0 Interface
Route Port,The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
baudrate is 192000 bps,
Internet Address is 2.2.2.10/24
Encapsulation is ISDN
Last physical up time
Last physical down time : 2010-08-15 00:31:30
Current system time: 2010-08-15 00:49:29
Issue 01 (2012-04-20)
Installing a 1BST interface card on the AR1200 and ensuring that it is registered
successfully
link-protocol ppp
PPP is configured as the link layer protocol of the interface.
link-protocol fr [ ietf | nonstandard ]
FR is configured as the link layer protocol of the interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Timeslot(s) Used: 1, 2
: 2010-08-15 00:33:01
11 ISDN BRI Interface Configuration
104