Configuring An Vdsl Interface In Ptm Mode - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Interface Management
AAL enabled: AAL5, Maximum PVCs: 16
PVCs on main-interface: 0 (Total PVCs: 1)
Last physical up time
Last physical down time : 2012-03-14 13:49:09
Current system time: 2012-03-14 16:58:58
Port PHY type
The physical up times since the system startup : 1
Last 300 seconds input rate 120 bits/sec, 0 packets/sec
Last 300 seconds output rate 1112344 bits/sec, 1311 packets/sec
Input:
OAM Cells:
Packet Errors:
Output:
OAM Cells:

13.5 Configuring an VDSL Interface in PTM Mode

This section describes how to configure an VDSL interface in PTM mode.
Applicable Environment
When an VDSL interface works in PTM mode, the VDSL line carries Ethernet packets.
Ethernet frames do not need to be fragmented into ATM cells. 1483B/1483R encapsulation,
ATM Adaptation Layer 5 (AAL5) encapsulation, and ATM cell encapsulation are not required,
enabling Ethernet services to be transmitted more rapidly than in ATM mode.
Pre-configuration Tasks
Before configuring an VDSL interface, complete the following tasks:
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface ethernet interface-number
The view of the VDSL interface working in PTM mode is displayed.
Step 3 Run:
ip address
The IP address of the VDSL interface is configured.
----End
Issue 01 (2012-04-20)
: 2012-03-14 13:49:37
: VDSL
469180146 packets, 49174924889 bytes
94834890 packets, 10052499551 bytes
Input bandwidth utilization
Output bandwidth utilization : 4.33%
Installing an VDSL interface card on the AR1200 and ensuring that it is registered
successfully
Configuring the VDSL interface in PTM mode
ip-address [ mask | mask-length ] [ sub ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
47700, ASM Cells:
0, Cell Errors:
0, ASM Cells:
: 0.01%
13 VDSL Interface Configuration
0
561137
0
130