Light Switch - Viking VCSB360 Service Notebook

1. Pull the knob from the control shaft.
2. Remove the one-half inch hex nut securing the control shaft to the control box cover.
3. Pry the three plastic caps from the control box cover.
4. Remove the three Phillips head screws securing the control box cover to the top of the cabinet.
5. Rotate the control box cover down to expose the contents of the control box.
6. Press down on the ends of the locking arm on the wiring connectors and unplug the two
connectors from the electronic control board.
7. Slide the old control board from the slots in the control box cover.
Servicing the Light Switch
The light switch that activates the lights inside the refrigerator section is located on the underside of the
control box.
1 . Follow the procedure described earlier to remove the control board cover from its position at the
top of the refrigerator section.
2. Unplug e yellow and black wire th
3. Press on the flexible arm of the light and pry the opposite side out
cover.
connectors from the light switch.
14
of the hole in the control box