Removing The Bimetal - Viking VCSB360 Service Notebook

1. Remove the two hex head screws from the fan motor bracket.
2. Remove the three wires from the terminals on the fan motor.
3. Remove the two hex head screws securing the fan motor to the mounting bracket and remove the
bracket from the motor.
4. If the motor is to be replaced, remove the blades from the motor shaft.

Removing the Bimetal

The bimetal is located behind the evaporator cover.
1. Push up on the bimetal bracket just enough to release the locator pin on the bimetal and remove
the bimetal from the bracket.
2. Unplug the connector from the wiring harness connector.
20