Door Assemblies; Replacing The Door Gaskets - Viking VCSB360 Service Notebook

Replacing the Door Gaskets

1. Fold the door gasket back and loosen but do not remove the hex head screws all around the
perimeter of the door.
2. Pull the lip of the gasket out from under the metal retaining strip and remove the gasket.
3. To install the new gasket, begin by sliding the lip under the retainer at the top of the door.
4. Tighten the screw in the top retainer just enough to hold the gasket in place.
5. Install the bottom edge of the gasket under the metal retaining strip in the same manner as the top.
6. Beginning at the center of the gasket on the right side, work toward the top of the door, sliding
the lip under the met al retaining strip, tighten the screws as you go along.
7. Install the lower half of the gasket in the same manner. Follow the same procedure for the left
side of the door.
8. Check the entire gasket to make sure it seals properly and that the door is not warped. It may be
necessary to loosen the screws and adjust the gasket or straighten the door. Be sure to tighten all
of the screws securely when the gasket is properly installed and the door is aligned with the
cabinet.

DOOR ASSEMBLIES

28