Adjust Door Swing; Level Refrigerator - Viking VCSB360 Service Notebook

ADJUST DOOR SWING, if needed.
Remove top grill by removing four 1/4" (6 mm) screws located behind the panel assembly. Remove door stop set
screw located in top and bottom hinges using a T-15 Torx wrench. Hold door in the desired position and replace set
screw. If door does not clear countertop after the door stop has been adjusted, countertops may need to be mitered.

LEVEL REFRIGERATOR

•
Turn rear leveling rods clockwise with a 5/16" (8mm) socket and ratchet until cabinet weight is supported
by rear legs. Lower front leveling legs with channel lock pliers until weight of the cabinet is supported by
the legs. NOTE: All four legs must contact the floor to support and stabilize the full weight of the
refrigerator.
•
Remove all tape and door bracing from refrigerator and freezer doors. Open doors. Place a level against
underside of door trim, on refrigerator product guides, and on freezer basket guides as shown. Adjust front
leveling legs and right and left rear rods until refrigerator is level and at the proper height. Check that all
four leveling legs contact floor and support the full weight of the refrigerator. Doors need to be installed
when leveling.
•
Check that both refrigerator and freezer doors are aligned and level. If doors need to be adjusted Left to
Right or In or Out, loosen the 3/8" (9mm) hex head screws in the top hinges. If doors need to be
adjusted Up or Down, loosen the 3/8" (9mm) hex screws in the bottom hinges. Adjust doors. Tighten
screws. Check that the doors are aligned and level.
62