Installing Custom Side Panels - Viking VCSB360 Service Notebook

If built-in area depth is 25" (63.5 cm) or more, custom side panels can be installed inside the side trim or attached to
the outside of the side trim. If the side panels will be installed inside the side trim and the panels are more then 1/8"
(3.2 mm) thick, route front edge of panel to fit side trim piece. If panels are less than 1/8" (3.2 mm) thick, install a
filler panel between sides and custom side panels. Follow specific installation instructions provided with custom
INSTALLING TOP GRILL
To remo ve:
1. Grasp louver area.
2. Push straight up, then pull straight out.
3. Loosen (4) screw
from unit.
INS TALL DIFFERENT H
1. Grasp louver area.
2. Push straight up, then pull straight out.
3. Loosen (4) screw
from unit.
4. Remove louvers from mounting brackets.
Align new brackets with holes on one end of
louvers. Fasten
at opposite end.
5. Remove screws attaching top trim to guard.
Readjust trim according to new grill height.
6. Replace end caps with
with new grill height.
7. Reattach grill assembly.
8. Replace louver assembly
slightly to lock into place.

INSTALLING CUSTOM SIDE PANELS

s to remove grill assembly
EIGHT TOP GRILL
s to remove grill assembly
in place with screws, repeat
ones that correspond
. Pull down
63