Removing The Defrost Timer; Removing The Run Capacitor - Viking VCSB360 Service Notebook

1. Press the flexible arms against the switch body and push the switch out of the cutout.
2. Disconnect the four wires from the power switch terminals.
3. When installing a new power switch, slide the connectors from the power cord onto terminals six
and three of the switch. Slide the two remaining onto terminals two and five.

Removing the Defrost Timer

The defrost timer is located on the component assembly cover.
1. Remove the two hex head screws securing the defrost timer to the component cover.
2. Unplug the wiring harness connector from the defrost timer.

Removing the Run Capacitor

The run capacitor is located on the left side of the
component cover.
1. Remove the hex head screw securing the run
capacitor to the side of the compartment cover.
2. Disconnect the two wire connectors from the
run capacitor.
25