Hp Trusted Platform Module - HP BL465c Gen8 Maintenance And Service Manual

While holding the system board in place, turn the base pan on the side and install the four screws on
4.
the bottom of the base pan.
Place the server blade on a flat, level work surface.
5.
IMPORTANT:
board.
Install the heatsink blank
6.
If a capacitor pack option is installed and cabled to a mezzanine option, install this capacitor pack and
7.
route the cable to the mezzanine option. For more information on routing the cables, see "FBWC
capacitor pack cabling
Install all DIMMs ("DIMMs" on page 28).
8.
Install the DIMM baffle and connect the drive cable to the SAS controller
9.
Install the front panel/drive cage assembly
10.
Install the hard drives ("Drive" on page 25).
11.
Install the hard drive blanks
12.
Install the access panel
13.

HP Trusted Platform Module

The TPM is not a customer-removable part.
CAUTION:
the TPM security rivet. Upon locating a broken or disfigured rivet on an installed TPM,
administrators should consider the system compromised and take appropriate measures to ensure
the integrity of the system data.
If you suspect a TPM board failure, leave the TPM installed and remove the system board
page 49). Contact an HP authorized service provider for a replacement system board and TPM board.
Install all components in the same configuration prior to removing the system
("Heatsink blank" on page 40).
("Capacitor pack
("Drive blank" on page 25).
("Access panel" on page 24).
Any attempt to remove an installed TPM from the system board breaks or disfigures
cabling" on page 64)."
("Front panel/drive cage
Removal and replacement procedures 59
("DIMM baffle" on page 27).
assembly" on page 39).
("System board" on