HP BL465c Gen8 Maintenance And Service Manual page 45

To remove the component:
Power down the server blade (on page 22).
1.
Remove the server blade (on page 23).
2.
Remove the access panel
3.
CAUTION: Always disconnect the drive cables from the SAS controller before removing the
DIMM baffle. Failure to do so may result in damage to the SAS controller.
Disconnect the drive cables from the SAS controller and remove the DIMM baffle
4.
page 27).
Remove all hard drives ("Drive" on page 25).
5.
Remove the front panel/drive cage assembly
6.
Remove the heatsink ("Heatsink" on page 42).
7.
Open the processor socket retaining bracket and the processor locking lever.
8.
Using the processor tool, remove the processor from the system board.
9.
("Access panel" on page 24).
("Front panel/drive cage
("DIMM
assembly" on page 39).
Removal and replacement procedures 45
baffle" on