Automationdirect.com DL05 User Manual page 442

DL05 Error Code
E603
DATA MISSING
E604
REFERENCE
MISSING
E620
OUT OF MEMORY
E621
EEPROM NOT
BLANK
E622
NO HPP EEPROM
E623
SYSTEM EEPROM
E624
V-MEMORY ONLY
E625
PROGRAM ONLY
E626
PROM MC
E627
BAD WRITE
E628
EEPROM TYPE
ERROR
E640
COMPARE ERROR
E641
VOLUME LEVEL
E642
CHECKSUM ERROR
E650
HPP SYSTEM
ERROR
E651
HPP ROM ERROR
E652
HPP RAM ERROR
Description
A search function was performed and the data was not found.
A search function was performed and the reference was not found.
An attempt to transfer more data between the CPU and handheld
programmer than the receiving device can hold.
An attempt to write to a non-blank EEPROM in the handheld programmer
was made. Erase the EEPROM and then retry the write.
A data transfer was attempted with no EEPROM (or possibly a faulty
EEPROM) installed in the handheld programmer.
A function was requested with an EEPROM in the handheld programmer
which contains system information only.
A function was requested with an EEPROM in the handheld programmer
which contains V-memory data only.
A function was requested with an EEPROM in the handheld programmer
which contains program data only.
An attempt to transfer data from a tape to a UVPROM Memory Cartridge.
This transfer must be made using a CMOS RAM Cartridge.
An attempt to write to a write-protected or faulty EEPROM in the handheld
programmer was made. Check the write protect jumper and replace the
EEPROM if necessary.
The wrong size EEPROM is being used in the handheld programmer. This
error occurs when the program size is larger than what the HPP can hold.
A compare between the EEPROM handheld programmer and the CPU was
found to be in error.
The volume level of the cassette player is not set properly. Adjust the volume
and retry the operation.
An error was detected while data was being transferred to the handheld
programmer's Memory Cartridge. Check cabling and retry the operation.
A system error has occurred in the handheld programmer. Power cycle the
handheld programmer. If the error returns replace the handheld programmer.
A ROM error has occurred in the handheld programmer. Power cycle the
handheld programmer. If the error returns replace the handheld programmer.
A RAM error has occurred in the handheld programmer. Power cycle the
handheld programmer. If the error returns replace the handheld programmer.
DL05 Error Codes
B–7