−
5.
If the packets are discarded after being sent to the CPU, contact HP Support.
6.
Execute the bcm <slot> <chip> l3/defip/show command in probe view to determine whether the
routing entries are correct and whether the packets match the routing entries.
7.
If the problem persists, contact HP Support.
Packet loss in data forwarding
Symptom
Packet loss occurs in data forwarding.
Solution
To resolve the problem, see "错误!未找到引用源。."
Related commands
This section lists the commands that you might use for troubleshooting SAP modules.
Command
bcm <slot> <chip> l3/defip/show
bcm <slot> <chip> l3/l3table/show
bcm <slot> <chip> show/counter
debugging physical packet [all | input | output ]
interface interface-number
display counters [inbound|outband] interface
display interface interface-number
reset counters interface
If the command does not display packet information, packets are not sent to the CPU. Enter
probe view and execute the bcm <slot> <chip> show/counter command to display statistics
about packet loss and contact HP Support.
Description
Displays information about routing entries.
Displays ARP entries.
Displays traffic statistics and data rate for an
interface.
Displays information about the packets sent to the
CPU.
Displays traffic statistics on an interface.
Displays information about an interface.
Clears traffic statistics on an interface.
16