Related Commands - HP HSR6600 Troubleshooting Manual

Failed. No response received from the active MPU.
GDSYNC_SendRequest: Start
GDSYNC_SendRequest: Start
GDSYNC_SendRequest: Start
GDSYNC_SendRequest: Start
GDSYNC_SendRequest: Start
GDSYNC_Start failed!
SYNC failed.
Replace the LPU with an LPU that can operate correctly. Install the original module in another
slot.
−
−
−
If the following information is displayed repeatedly, the Comware image files are not correctly

loaded.
%Jul 17 14:01:48:947 2014 HP DEV/3/LOAD_FAILED: -MDC=1; Board in slot 3 failed to
load software images.
%Jul 17 14:01:48:948 2014 HP DEV/3/LOAD_FAILED: -MDC=1; Board in slot 3 failed to
load software images.
Perform the following tasks:
−
−
6. Identify whether the Comware image files have been correctly started. If any of the following
symptoms appear, contact HP Support:
The system stops at the System image is starting... message.

The system stops responding after displaying the System image is starting... message and some

other information.
The system reboots after displaying the System image is starting... message. This symptom

occurs repeatedly.
After the system displays the System image is starting... message and the Change to Normal

message for the LPU, the LPU reboots repeatedly.

Related commands

This section lists the commands that you might use for troubleshooting card problems:
Command
display device
If neither of the LPU can start up correctly either, the MPU or chassis might have problems.
Contact HP Support.
If the new LPU can start up correctly but the original LPU cannot, the original LPU has
problems.
If the new LPU cannot start up correctly, the IPC channel of the slot has problems. Contact HP
Support.
Verify that the Comware software is an officially released version.
Identify whether the version supports the LPU.
Description
Displays device information.
28