Serial Port Configuration - Silicon Laboratories SLWRB4150A User Manual

■
Built-in Help
The admin console has a built in help system which is accessed by the
level commands:
WSTK> help
*************** Root commands ****************
aem AEM commands
boardid Commands for board ID probe.
dbg Debug interface status and control
dch Datachannel control and info commands
discovery Discovery service commands.
net Network commands.
pti Packet trace interface status and control
quit Exit from shell
sys System commands
target Target commands.
time Time Service commands
user User management functions
The command can be used in conjunction with any top level command to get a list of sub-commands with description. For exam-
help
ple, will print a list of all available sub-commands of
pti help
WSTK> pti help
*************** pti commands ****************
config Configure packet trace
disable Disable packet trace
dump Dump PTI packets to the console as they come
enable Enable packet trace
info Packet trace state information
This means that running
pti enable
■
Command Examples
PTI Configuration
pti config 0 efruart 1600000
Configures PTI to use the "EFRUART" mode at 1.6 Mb/s.

Serial Port Configuration

serial config vcom handshake enable
Enables hardware handshake on the VCOM UART connection.
silabs.com | Smart. Connected. Energy-friendly.
[ calibrate, current, dump, ... ]
[ list, probe ]
[ info, mode,]
[ dnslookup, geoprobe, ip ]
[ nickname, reset, scratch, ... ]
[ button, flashwrite, go, ... ]
[ client, server ]
[ login,]
pti
will enable packet trace.
UG178: EFR32MG 2400/868 MHz 13 dBm Dual Band Radio Board
command. The
help
[ info ]
[ config, disable, dump, ... ]
:
Board Controller
command will print a list of all top
help
Rev. 1.00 | 17