Replacing The Wiper - Roland SJ-740 User Manual

4-3 Replacing the Wiper

If the message shown in the figure appears, replace the wiper with a new part.
Follow steps 1 through 3 in "4-2 Cleaning Us-
1
ing the Cleaning Kit" to display the screen
shown in the figure.
Follow steps 4 through 6 in "4-2 Cleaning Us-
2
ing the Cleaning Kit" to detach the right cover,
and discharge static electricity from your body.
Using tweezers, grasp the bottom portion of the
3
wiper and take it off the hook.
4 Remove the wiper.
The wiper has a rubber surface and a felt surface. Attach
it so that the rubber surface faces the front.
Install the new wiper.
5
Use the tweezers to press the area shown in
the figure and engage the wiper on the hook.
When installing the wiper, be sure to engage it on the hook.
If the wiper is not hooked, it may fall off during use. Use
the included tweezers to install and detach the wiper.
6 Follow steps 11 through 13 in "4-2 Cleaning
Using the Cleaning Kit" to attach the right cover
and carry out a printing test.
TIME FOR
WIPER REPLACE
MAINTENANCE
WIPER REPLACE
Bottom portion of the wiper
Felt
Rubber
Hook
Chapter 4 - Maintenance
67