What To Do If An Error Message Appears - Roland SJ-740 User Manual

6-2 What to Do If an Error Message Appears

Messages
CLOSE THE COVER
SHEET NOT LOADED
PRESS SETUP KEY
1_ 2 3 4 5 6
7_ 8 9 10 11 12
SET SOL CRT.
1 2 3 4 5 6 7 8 9 10 11 12
REMOVE SOL CRT.
1 2 3 4 5 6 7 8 9 10 11 12
SET SOL CL-LIQUID
1 2 3 4 5 6 7 8 9 10 11 12
REMOVE SOL CL.
1 2 3 4 5 6 7 8 9 10 11 12
EMPTY
DRAIN BOTTLE
INSTALL
DRAIN BOTTLE
TO CANCEL, HOLD
DOWN SETUP KEY
DRY-UP OF HEAD
MAY GIVE DAMAGE
DO NOT USE
MEDIA CLAMPS
* [1 2 3 4 5 6 7 8 9 10 11 12] indicate the numbers of the ink-cartridge ports. The character indicating the number of the ink-
cartridge port flashes when action is necessary.
[Example]
SET SOL CRT.
123456789101112
Meaning
An operation command was given while the
cover or front cover is open.
Test printing was attempted with no media
loaded.
Ink has been used up.
* The message at left indicates that the cartridge
No.1 and No.7 have been used up.
An ink cartridge was removed.
A request to insert an ink cartridge was made
from this machine.
A request to remove an ink cartridge was made
from this machine.
A request to insert a cleaning cartridge was made
from this machine.
A request to remove a cleaning cartridge was
made from this machine.
Discard discharged ink.
* This message appears before operations that
will discharge large amounts of ink.
There is a chance of discharged ink overflow-
ing if operations are carried out while the drain
bottle is full.
Check that the drain bottle is set in position.
Operation was paused by pressing the [PAUSE]
key, but there is still some remaining data.
Emergency stop was effected.
* "CLOSE THE COVER" is also displayed
repeatedly.
Audible alert each 10 sec.
After 1 min., audible alert goes continuously.
Do not use media clamps.
*This message appears when position the
printing head at 1 (low).
If "4, 5, 10, 11" is flashing:
Install ink cartridges in ink-cartridge ports 4, 5, 10, and 11.
Action
Close the cover or front cover.
Load the media and try again.
Press the [ENTER] key to continue.
Replace the empty ink cartridge.
Insert the specified ink cartridge.
Take out the specified ink cartridge.
Insert the specified cleaning cartridge.
Take out the specified cleaning cartridge.
Remove the drain bottle from this machine,
discard the collected ink, then reinstall the drain
bottle. Press the [ENTER] key to continue.
Set the drain bottle in place. Press the [ENTER]
key to continue.
Pressing the [PAUSE] key again to resume
operation.
Press the [SETUP] key to clear the data.
Close the cover or front cover.
* When restarting print, such detect like raster
line or shift of band may happen.
Detach media clamps to the media.
Press the [ENTER] key to continue.
Chapter 6 What to Do If...
91