Description Of Menus - Roland SJ-740 User Manual

5-2 Description of Menus

Top menu
SHEET TYPE
PRINT AREA RIGHT EDGE
LEFT EDGE
HEAD
HEIGHT
HEAD CLEANING
ALL MEDIUM
A MEDIUM
B MEDIUM
C MEDIUM
ALL POWERFUL
A POWERFUL
B POWERFUL
C POWERFUL
Chapter 5 -Menus and Keys
78
Submenu
— This is used to select either transparent or opaque media.
Select [OPAQUE] when the media loaded on the unit is not transpar-
ent. When you are using transparent media or the printing area can-
not be detected, select [CLEAR]. For more information, see "3-5
Using Transparent Media."
* This appears only when the media is in a loaded state.
This sets the printing area in the left-right direction (the direction of
printing carriage movement) of the loaded media.
With transparent media, automatic detection of the media width is
not performed. In such cases, use the [PRINT AREA] menu to specify
the printing area in the left-right direction. Even when using opaque
media, this can be specified when printing in a specific area.
For more information, see "3-3 Setting the Location Where Printing
Starts -- Specifying a location in the feed direction."
This sets the height of the printing heads.
To make the setting, display this menu, then move the lever on the
side of the unit's printing carriage.
For more information, see "2-2 Loading Media -- When Loading
Thick Media ."
If print shows a problem, clean the printing head.
Because cleaning subjects the head to wear and consumes ink, it
should only be performed when absolutely necessary. Performing
cleaning from the Powerful menu in particular subjects the head to
early wear and used up large amounts of ink.
[ALL MEDIUM]/[A MEDIUM]/[B MEDIUM]/[C MEDIUM]: Per-
forms cleaning of the printing heads. After cleaning, carry out a
printing test to make sure there are no problems with printing qual-
ity.
Normally, head cleaning should be performed by pressing the
[CLEANING] key.
[ALL POWERFUL]/[A POWERFUL]/[B POWERFUL]/[C POW-
ERFUL]: Used when performing cleaning with Medium several times
does not restore the printing quality. After cleaning, carry out a print-
ing test to make sure there are no problems with printing quality.
For more information, see "2-3 Printing -- Performing a Printing Test"
and "4-1 Cleaning the Printing Heads."
Function Setting Default
range value
OPAQUE/ OPAQUE
CLEAR
— —
H I G H / MIDDLE
M I D D L E /
LOW
— —