Timed Start Program; Timed Start Operation - Audiovox PRO-9675FT Installation Manual

To Program The Alarm's Selectable Features:
Action
Turn the ignition switch on
Flip the valet/program switch on then off 3 times
Within 3 seconds, turn the ignition switch off
and then on.
First Press the transmitter's Arm/Disarm to toggle
between the three selections.
Or
Flip valet/program switch on then off
Second
Press the transmitter's Arm/Disarm button to
change.
Or
Third Flip valet/program switch on then off
Press the transmitter's Arm/Disarm button to
change.
Or
Flip valet/program switch on then off
Fourth
Press the transmitter's Arm/Disarm button to
change.
Or
Flip valet/program switch on then off
Fifth
Press the transmitter's Arm/Disarm button to
change.
Or
Flip valet/program switch on then off
Or
Turn ignition switch off.
NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass between steps, or
the programming mode will be terminated.

TIMED START PROGRAM:

The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature is
useful in extremely cold climates where starting the engine is the only means to keep the battery charged
and fluids warm. The operator has the option to have the unit start every 2 or 4 hours for a maximum of 48
hours. Factory pre-set is to start at 4 hour intervals. To select 2 or 4 hour automatic start timer:
1. Start with the Enable switch (Red Handle) in the "On" Position.
2. Turn the ignition on then off.
3. Within 10 seconds of the key turning off, cycle the enable switch Off, On, Off, On ( 2 times) to select
a 2 hour timed start interval. Cycle the enable switch Off, On, Off, On, Off, On, Off, On (4 times) to
select a 4 hour timed start interval. The lights will flash and the siren will chirp 2X or 4X dependant upon
2 or 4 hour interval setting.
Once selected, 2 or 4, this timer interval will remain in memory until it is manually changed. To
NOTE:
change, the above sequence will have to be followed.

TIMED START OPERATION:

To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF command to
start 2 times. (Press the upper left button four times). The lights will flash and the siren will chirp 4 times.
Indicating timed interval mode has been initiated. The vehicle will automatically start every 2 or 4 hours as
programmed. To cancel the timed start mode start the vehicle either by RF or by the ignition key.
System Response
No Response
1 Chirp-LED 1 Flash
Short Chirp, then Long Chirp
1 Chirp = 1 second Locks
2 Chirps = 3.5 second Locks
3 Chirps = 1 Second Lock &
Double 1 Second Unlock
2 Chirps = auto locks off
1 Chirp = auto locks on
2 Chirps = auto unlock off
1 Chirp = auto unlock on
2 Chirps = active locks
1 Chirp = passive locks
1 Chirp = passive arming
2 Chirps = active arming
1 Long Chirp
Exit Program Mode
1 Long Chirp
Exit Program Mode
15
LED Flash Pattern
1 Flash Pause etc.
2 Flash Pause etc.
3 Flash Pause etc.
4 Flash Pause etc.
5 Flash Pause etc.
128-5371
15 of 22