1. Manuals
  2. Brands
  3. Audiovox Manuals
  4. Car Alarm
  5. Pursuit PRO-9671FT
  6. Owner's manual

Audiovox Pursuit PRO-9671FT Owner's Manual

Pursuit series 3 button remote start security system with plug-in shock sensor & starter disable
Hide thumbs Also See for Pursuit PRO-9671FT:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction and Installation Manual
3 Button Remote Start Security System With
Plug-In Shock Sensor & Starter Disable
2 Three Button Programmable RF Transmitters
Four Channel Code Learning Receiver
Remote Start Safety Control Switch
Safe Start RF Control (Double Push Of RF Transmitter)
Selectable Automatic Timed Start Mode
7 Function LED, Arming, Armed, Disarmed, Valet, Zones 1, 2, & 3
Audible Arm, Disarm, Defect Zone, And Intrusion Indications
Instant Siren Activation All Entry Points
Selectable Run Time 10 or 15 Minutes
CAUTION! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon monoxide
fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT
remote start the vehicle if the car is garaged.
Model PRO-9671FT
FEATURES:
Anti Code Grabbing Technology
Remote Panic In All Modes
Protected Valet/Override
Intrusion Alert With Memory
Starter Disable When Armed
True Last Door Arming
Defective Zone By-Pass
On Command RF Chirp Delete
6 Tone Multi-Tone Siren
Two Stage Shock Sensor
OPTIONS:
Remote Trunk Release
Remote Keyless Entry
Illuminated entry
Remote Power Window Control
Remote Garage Door Interface
Multiple Vehicle Capable
Page 1
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for Audiovox Pursuit PRO-9671FT

Summary of Contents for Audiovox Pursuit PRO-9671FT

  • Page 1 3 Button Remote Start Security System With Plug-In Shock Sensor & Starter Disable 2 Three Button Programmable RF Transmitters Four Channel Code Learning Receiver Anti Code Grabbing Technology Remote Panic In All Modes Protected Valet/Override Remote Start Safety Control Switch Safe Start RF Control (Double Push Of RF Transmitter) Selectable Automatic Timed Start Mode 7 Function LED, Arming, Armed, Disarmed, Valet, Zones 1, 2, &...

  • Page 2: Arming The System - Active

    Your PRO-9671FT Remote Start Alarm System has many features and available options some of which are selected at time of installation. For your reference, the list on the back page of this manual show what features and options have been installed. Consult your installing dealer for options that may have been installed and are not listed.

  • Page 3: Disarming The System

    sound for six 30 second cycles than shut down, isolate the triggered zone and continue to protect all other zones. Whenever the system is armed, the dash mounted LED will slowly flash. This serves as a visual deterrent to a potential thief. This LED is a very low current light emitting diode, and will not cause the battery to drain even if left unattended for long periods of time.

  • Page 4: Valet/System Override Switch

    the dash mounted LED's flash pattern. The number of flashes identifies the triggered zone. For additional information, refer to INTRUSION WARNING SIGNALS found later in this manual. INTRUSION WARNING SIGNAL This system will inform you if an intrusion attempt has occurred while you were away from the vehicle.

  • Page 5: Remote Panic Operation

    1. Start with the valet switch in the off position. 2. Turn the ignition switch on then off. 3. Within 10 seconds of turning off the ignition, flip the valet switch on, off, on, off, on, off. 4. If the chirps were on before you started, the siren will emit 2 short chirps indicating that the chirps are now off.

  • Page 6: Operating On Automatic Start Up Timer Mode

    To Remote Start The Vehicle: Press and release channel 2 of your keychain transmitter two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 10 or 15 minutes. As a visual indication, the parking lights will flash or turn on dependent on the programming set up by your installation center.
  • Page 7 CANCELING THE AUTOMATIC START UP TIMER To cancel the automatic start up timer do one of the following; 1. Start the vehicle manually with the use of the ignition key and depress the brake pedal. 2. Remote start the vehicle using your keychain RF transmitter. ADDITIONAL REMOTE FUNCTION CHANNEL 2 The system has an additional feature, ( Channel 2) ,that can be connected to a number of different optional accessories.
  • Page 8 3 FLASH CONTINOUS FLASH REMOTE START SIREN INDICATIONS 1 LONG/1SHORT REMOTE START PARKING LAMPINDICATIONS 1 FLASH CONTINOUS FLASH © 1998 Audiovox Corp., Hauppauge, N.Y. 11788 PASSIVE ARMING ARMED DISARMED VALET MODE INTRUSION ZONE 3 INTRUSION ZONE 2 INTRUSION ZONE 1...

Table of Contents