Table of Contents
Advertisement
Quick Links
3 Button Remote Security System with Starter Disable
IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need to
manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such situa-
tions. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected. Valet
Switch manual override is pre-selected from the factory, however, the system can be
configured for "Custom Code" operation. Confirm the override mode selected on the last page
of this manual and familiarize yourself with the section on it's operation.
FEATURES :
w 2 Three Button Programmable RF Transmitters (capable of accepting 4 transmitters)
w Separate Lock/Unlock Transmitter Buttons
w Five Channel Receiver
w Anti Code Grabbing Technology
w Selectable Manual Override Mode
w Remote Panic in all modes (Improved)
w Protected Valet
w User Programmable Manual Override Code
w 7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Starter Disable
w True Last Door Arming ( hardwire only )
w Defective Zone By-Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w Smart Disarming
w Programmable Auto Lock On / Off
w Programmable Auto Unlock On / Off
w Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
w Programmable Active or Passive Door Locks
w User Programmable Permanent Chirp Delete
w On Command RF Chirp Delete from Transmitter Or Selectable Through Software
w 6 Tone Multi-Tone Siren, (And Or),
w Car Horn Activation for additional alarm response
w Additional Negative Trigger Input
w RF Inhibit with ignition on
w Parking Light Flasher
OPTIONS :
w Remote Trunk Release ( must have electronic trunk release )
w Remote Keyless Entry ( must have power door locks )
w Illuminated Entry
w Multiple Vehicle Capable
w Headlight Illumination during Arming and or Disarming
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface
w Plug In Electronic Shock Sensor
Model PRO 9644
Owner's Manual
Advertisement
Table of Contents
Related Manuals for Audiovox PRO 9644
Summary of Contents for Audiovox PRO 9644
- Page 1 Illuminated Entry w Multiple Vehicle Capable w Headlight Illumination during Arming and or Disarming w Remote Starter w Remote Power Window Roll Up w Remote Garage Door Interface w Plug In Electronic Shock Sensor Model PRO 9644 Owner’s Manual...
-
Page 2: Arming The System - Active
YOUR " ANTI CODE GRABBING " TRANSMITTERS The transmitters included with your new security system use the most advanced and secure form of radio frequency transmission available on any current automotive security system. Some of today’s sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and re-transmit at a later time to disarm your system. -
Page 3: Arming The System - Passive ( Automatic )
If the horn beeps three times, then you have left a door, trunk, or hood lid ajar. Simply close the opened entry point to provide full protection. o Doors Lock - Optional o Headlight Illumination - Optional The vehicle’s headlights turn on for approximately 30 seconds, illuminating the path as you leave the vehicle. -
Page 4: Disarming The System
o Optional - Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle. DISARMING THE SYSTEM 1. As you approach the vehicle, press and release the Unlock button on the keychain trans- mitter. -
Page 5: While The System Is Sounding
flashing rapidly, indicating that the system is re-arming automatically. Open any door to suspend the automatic arming. þ Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered. -
Page 6: Valet Switch
to a light activated entry point if the alarm was installed using the voltage sensing feature. Ž If the LED is flashing three times...pause...three times...pause...etc., then an intrusion attempt was made through one of the vehicle’s doors. These intrusion warning indicators are stored in the system’s memory, and will only be erased when the ignition key is turned on. - Page 7 4. Within 10 seconds, begin to enter your chosen 10ths digit by pressing and releasing the pushbutton switch from 1 up to 9 times. 5. Within 10 seconds of the last entered 10ths digit, turn the ignition switch off then on. 6.
-
Page 8: Eliminating The Normal Arm / Disarm Chirps
MANUALLY OVERRIDING YOUR SYSTEM: USING THE CUSTOM CODE OVERRIDE Assuming the override code programmed has not been changed, and the default override code of 11 is in the system's memory. 1. Enter the vehicle and turn the ignition switch to the on position. NOTE: The siren will sound. - Page 9 OPTIONAL DEVICE OUTPUT (CHANNEL 3) Controlled By: o Option Button, o Both Lock & Unlock Button, o Both Option & Lock Button, or Both Option and Unlock Button. This security system is equipped with an output which will activate when the appropriate transmitter button is depressed for four seconds.
- Page 10 Headlight Illumination during arm & disarm o Passive Arming o No Lock in passive mode o Hardwire doors, hood, and trunk o Custom Code Override o Valet Switch Override © 2001 Audiovox Electronics Corporation, Hauppauge, N.Y. 11788 PRO 9644 PASSIVE ARMING ARMED DISARMED VALET MODE...