Related Manuals for Contura C 850W
Summary of Contents for Contura C 850W
- Page 1 Installation Installation instruction Installasjonsanvisning Monteringsvejledning instruction Guide d’installation C 850W www.contura.eu...
- Page 2 See rating plate on the stove Intended area of use Heating of rooms in residential buildings Fuel Wood MANUFACTURER Name NIBE AB / Contura Address Box 134, Skulptörvägen 10 SE-285 23 Markaryd, Sweden CHECKS According to AVCP System 3 European standard...
- Page 3 A warm welcome to the Contura family. We hope you will get a great deal of pleasure from your new stove. As a new owner of a Contura stove, you have secured a product with timeless design and long service life.
-
Page 4: Technical Details
FACTS Technical details Important to remember! Installation by authorised Structural support Effect 3-6 kW Nominal effect 4 kW technician The wall must be strong enough to bear the Efficiency up to 82% weight of the stove and chimney. This manual contains instructions about how the stove must be assembled and Model 850W... -
Page 5: Connection To Chimney
CHIMNEY Connection to chimney • The stove meets the requirements for connecting to chimneys • A flue with sharp bends and horizontal routing reduces the dimensioned for 350°C flue gas temperature. draught in the chimney. The maximum horizontal flue is 1 m, on the condition that the vertical flue length is at least 5 m. -
Page 6: Supply Of Combustion Air
INSTALLATION DISTANCE / SUPPLY Installation distances C 850W Combustible roof Brännbart tak Firewall*** Brandmur *** 200** 430** Brännbar vägg Combustible wall Brandmur *** Firewall*** Ext. Ø150 Utv. Ø150 Air inlet Ø67 Tilluftsstos Ø67 ** To prevent discolouration of painted non-flammable walls we recommend that the same side distance as to combustible walls is used. - Page 7 ASSEMBLY Installing of C 850W Ø 8 mm Position the back plate opposite the connector. Check that the back plate is vertical and mark the mounting holes that you intend to use. Choose a hole so that it ends up as far away from any mortar joints as possible.
- Page 8 ASSEMBLY 5 0 m m Ensure that the pipe protrudes 50 mm from the back plate and seal using the sealing yarn between the wall connector and the connection pipe. If further sealing material is required, heat- resistant sealant may be used.
- Page 9 ASSEMBLY...
- Page 10 ASSEMBLY Secure the brackets using 2 screws at the lower edge.
- Page 11 ASSEMBLY Place the rating plate with production number and installation distance on the protective plate with the plate turned downwards.
- Page 12 ASSEMBLY Final inspection of the installation It is extremely important that the installation is inspected by an authorised chimney sweep before the stove is used. Also read the "Lighting instructions" before lighting for the first time.
-
Page 13: Removal
REMOVAL Removal How to remove the firebricks Handle the firebricks with care. Lift the smoke baffle with one hand whilst removing the sides. The side posts need not be removed when sweeping. Reinstall in reverse order. - Page 16 NIBE AB · Box 134 · SE-285 23 Markaryd · Sweden www.contura.se Contura reserves the right to change dimensions and procedures described in these instructions at any time 811222 IAV SE-EX C850W-2 without special notice. The current edition can be downloaded 2014-01-08 from www.contura.eu...