Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Contura C 32
Summary of Contents for Contura C 32
- Page 1 Installation Instructions C 32 C 32A www.contura.eu...
- Page 2 Contura 32/32A is a Swan-labelled wood burning stove. NIBE was the first stove manufacturer in Sweden to commit to Swan labelling stoves. The Swan label is one aspect of our vision to be a company of the future, setting high quality standards regarding the environment.
-
Page 3: Table Of Contents
CONTENTS A warm welcome to Contura. A warm welcome to the Contura family. We hope you will get a great deal of pleasure from your new stove. As a new owner of a Contura stove, you have secured a product with timeless design and long service life. -
Page 4: Technical Details
FACTS Technical details Important to remember! Installation by authorised Structural support technician Output 3-7 kW Check that the wood joists are strong Nominal effect 5 kW enough to bear the weight of the stove This manual contains instructions about Efficiency and chimney. -
Page 5: Installation Distance To Walls And Ceiling
INSTALLATION DISTANCES Installation distance to walls and ceiling C32/C32A Combustible roof Place the stove on the hearth plate must be at least 1 m. and check that the installation When top connecting a steel flue, distances are not less than those please refer to the particular height from floor to chimney connection that are given in the figures below. -
Page 6: Supply Of Combustion Air
SUPPLY AIR/ACCESSORY Supply of combustion air Knockout To insert the combustion air hose, tap out the knockout from the Combustion air can be provided directly via a duct from floor panel and leg using a hammer, remember to protect the outside, or indirectly via a vent in the outer wall of the room floor. -
Page 7: Self-Closing Door
SELF-CLOSING DOOR Self-closing door The stove is equipped with a spring to close the door auto- matically. The spring is situated above the heat deflector. The closing force of the hatch can be adjusted by moving the spring between the three notches on the lever. After adjustment, the heat deflector must be reinstalled. -
Page 8: Connection To Chimney
CHIMNEY Connection to chimney • The stove meets the requirements for connecting to chimneys • A flue with sharp bends and horizontal routing reduces the dimensioned for flue gas temperatures of 350°C. draught in the chimney. The maximum horizontal flue is 1 m, on the condition that the vertical flue length is at least 5 m. - Page 9 Sweeping When sweeping, the smoke baffle must be removed; on the Contura 30 series this can be done by lifting the smoke baffle and removing the side piece. Lift the smoke baffle out and remove the remaining sections. Handle the parts with care.
-
Page 10: Installation Of Surround
ASSEMBLY Installation of surround The aluminium model Rating plate Important: Remove the protective plastic from along Place the rating plates on the lower heat deflector the bent edge before install- as illustrated. On the model with the drawer, the ing the back panel. type plates can be mounted inside the drawer. - Page 11 ASSEMBLY Final inspection of the installation It is extremely important that the installation is inspected by an authorised chimney sweep before the stove is used. Also read the ”Lighting instructions”, before lighting for the first time.
-
Page 12: Installing Accessories · Base
ASSEMBLY Installing accessories · Base Base When installing the base, the lower knockout in the back panel must always be removed for the supply of convection air. -
Page 13: Installing Accessories · Drawer
ASSEMBLY Installing accessories · Drawer Drawer Remove the front plastic screws in the drawer rails and discard them. Insert the screws in the hole of the rail as illustrated. The second screw is inserted in the rear section. Hold the rail as far out as possible and angle the front section downwards whilst you tighten the screws. - Page 14 ASSEMBLY Adjust the drawer so that it is centrally positioned in relation to the hatch and then tighten the screws.
-
Page 15: Installing Accessories · Log Box
ASSEMBLY Installing accessories · Log box Log box Adjust the pieces with the Allen screws so that they are in line with the hatch. - Page 16 NIBE AB · Box 134 · SE-285 23 Markaryd Sweden · www.contura.eu Contura reserves the right to change colours, materials, dimensions and models at any time without special notice. 811095 IAV SE-EX C32/C32A 1114-1 Your dealer can provide you with the latest information.