Desktop Or Shelf Mounting; Connecting To A Power Source; Installing An Optional Sfp Transceiver - AMX NXA-ENET8-2POE Instruction Manual

Desktop or Shelf Mounting

1. Attach the four adhesive feet to the bottom of the first NXA-ENET8-2POE (FIG. 18):
Attaching the Adhesive Feet
FIG. 18
2. Set the device on a flat surface near an AC power source, making sure there are at least two inches of space on all sides for
proper air flow.
3. If installing a single switch only, turn to the Connecting To a Power Source section on page 25.
4. If installing multiple switches, attach four adhesive feet to each one. Place each device squarely on top of the one below.

Connecting To a Power Source

To connect the NXA-ENET8-2POE to a power source:
1. Insert the power cable plug directly into the AC Power Inlet located on the rear panel (see FIG. 1 on page 13).
2. Plug the other end of the cable into a grounded, 3-pin, AC power source.
NOTE: For international use, you may need to change the AC line cord. You must use a line cord set that has been approved for
the wall socket type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure the Power LED is on green. If not, check that the power
cable is correctly plugged in.

Installing an Optional SFP Transceiver

The NXA-ENET8-2POE supports 1000BASE-SX, 1000BASE-LX, 1000BASE-LH, and 100BASE-FX SFP-compatible transceivers.
NOTE: SFP transceivers are not provided with the NXA-ENET8-2POE.
To install an SFP transceiver:
1. Consider network and cabling requirements to select an appropriate SFP transceiver type.
2. Insert the transceiver with the optical connector facing outward and the slot connector facing down. Note that SFP
transceivers are keyed so they can only be installed in one orientation.
3. Slide the SFP transceiver into the slot until it clicks into place (FIG. 19).
Installing an Optional SFP Transceiver into a Slot
FIG. 19
NXA-ENET8-2POE - Instruction Manual
Installation
25