Power Connector Cable - HP ProBook 4325s Maintenance And Service Manual

Power connector cable

NOTE: The power connector cable is included in the
599525-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Switch cover (see
b. Keyboard (see
c. Fan and heat sink (see
d. Speakers (see
Remove the power connector cable.
1. Position the computer right-side up with the front toward you.
2. Release the power connector cable from the system board (1).
3. Remove the modem cable (2) from the routing in the base enclosure.
4. Remove the power connector cable
Reverse this procedure to install the power connector cable.
76 Chapter 4 Removal and replacement procedures
Battery on page 45).
Switch cover on page
Keyboard on page 49)
Heat sink and fan on page
Speakers on page 56)
Cable kit on page 31, part number
47)
70)