HP ProBook 4325s Maintenance And Service Manual page 88

4. If it is necessary to replace the display bezel, display enclosure, or display hinges, remove the
four Mylar screw covers (1) and the four T8 slotted-Torx M2.5×6.0 screws (2) that secure the
display bezel to the display assembly. The screw covers are available in the rubber kit, spare
part number 599564-001.
5. Remove the bezel:
a. Flex the top of the bezel from the inside edge until it disengages from the display back
cover (1).
b. Flex the bottom of the bezel from the inside edge until it disengages from the display back
cover (2).
c. Flex the inside edge of the left side and the right side of the bezel until it disengages from
the display back cover (3).
d. Remove the display bezel from the display back cover (4).
80 Chapter 4 Removal and replacement procedures