j.
Display assembly (see
k.
Top cover (see
l.
Power connector and cable
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory module (see
●
WLAN module (see
●
Modem module (see
●
Processor (see
Remove the system board:
1.
Position the computer right-side up with the front toward you.
2.
Remove the T8 slotted-Torx 2.5×5.0 screw (1) that secures the system board to the base
enclosure.
3.
Disconnect the USB board cable from the system board (2).
4.
Use the ODD connector (3) to lift the right side of the system board from the base enclosure (4).
5.
Lift the system board up and to the right to remove the system board (5).
Reverse this procedure to install the system board.
90
Chapter 4 Removal and replacement procedures
Display assembly on page
Top cover on page
Memory module on page
WLAN module on page
Modem module on page
Processor on page
74)
77)
85)
51)
65)
87)