Table of Contents
Advertisement
1.
Important information on installing the CD changer in the E39
Only for use in the BMW dealer organisation.
The CD changer may only be installed by a specialist workshop that has the required special
tools and manuals (servicing, repair, diagnostics, etc.).
All the work is shown for the left-hand side of the car and must be repeated on the right-
hand side.
In cars with an on-board monitor radio the control cable is only installed in the boot.
In cars with a BMW Professional hi-fi system DSP amplifier only the coaxial cable for the
Professional hi-fi system DSP amplifier/CD change must be installed in the boot.
In cars with a small boot cover the boot cover for the CD changer may have to be ordered
separately from the electronic parts catalogue (EPC), depending on the equipment in the
car.
Ensure that the cables/lines are not kinked or damaged as you install them in the car.
Additional cables/leads that you install must be secured with cable ties.If the specified PIN
chambers are occupied, bridges, double crimps or twin-lead terminals must be used.
Subject to technical modifications
Required tools and equipment
Set of flat screwdrivers
Set of Philips screwdrivers
Angle cutter
1/4 inch socket set
Cable lamp
BMW disconnection tool
Hot air blower
Retrofit / Installation kit No. 65 12 0 029 649 (others see cover sheet)
Installation Instructions No. 01 29 0 029 574
Set of Allen keys
Drill
Set of drill bits
1/2 inch socket set
Set of step drill bits
Set of Torx sockets
Issue date: 05.2001
EN/3
Advertisement
Table of Contents
