Table of Contents
Advertisement
7 .
To install the CD changer (cars without an on-board monitor, without a DSP amplifier and
with Professional radio SA663 after production date 03/01 only)
42
41
19
40
Retrofit / Installation kit No. 65 12 0 029 649 (others see cover sheet)
Installation Instructions No. 01 29 0 029 574
A
B
41
40
F 39 0904 B
13
14
13
A3
F 39 0905 B
40
F 39 0906 B
Remove the left tail light unit.
0
Mark the drilling position (40) with a centre punch.
Dimension A = 19 mm
Dimension B = 17 mm
Remove the body paint and primer from the grey
area (41) in a diameter of 20 mm around the
position of the hole (40) on the front and rear of the
tail light unit (42).
The panel must be bare in the grey area (41), to
ensure that perfect contact is possible.
!
Risk of damage. Before drilling the hole
ensure that the cable and plug fastenings are
unclipped and the cables are removed from
the drilling area to prevent their being
damaged.
Drill the holes with a 6 mm drill bit.
Remove all the drill chips that are produced during
the drilling process using an extractor.
Then deburr the edges of the hole.
Push the hexagonal screw and washer (19) from
0
the rear into the hole (40) and secure it with a
hexagonal nut and washer M6 (13).
If you fit the earth connection cable later, ensure
that you fit the washer (14) first and then branch
A3.
Then secure branch A3 (the terminal lug with the
cable output must point downwards) using the
second hexagonal nut and washer M6 (13).
!
After securing the parts, treat all of them with
the anti-corrosion measures set out in the
BMW standard.
The figure shows the final installation position of
0
the earth connection cable.
The cable loom (40) must point downwards.
Issue date: 05.2001
EN/16
Advertisement
Table of Contents
