6.
To install the CD changer (cars without an on-board monitor, without a DSP
amplifier and with Professional radio SA663 up to production date 02/01 only)
X18180
0
0
Retrofit / Installation kit No. 65 12 0 029 649 (others see cover sheet)
Installation Instructions No. 01 29 0 029 574
A
F 39 0901 B
A1
X322
A
F 39 0902 B
A2
X322
A
F 39 0903 B
0
!
The installation of the power supply cable A
for the CD change is only necessary, if the
black 3-pin socket casing X18180 on the
power supply for the CD changer is not tied
back on the audio wiring harness.
Disconnect the white 12-pin plug connector X322.
0
Disconnect the existing socket contact from slot
PIN4, white/grey/yellow cable on the white 12-pin
socket casing X322B.
Connect branch A1, 1-pin socket contact, white/
grey/yellow cable on the power supply cable A to
the white 12-pin socket casing X322B in slot
PIN4.
Connect the supplied 1-pin black socket casing to
the disconnected socket contact and connect it to
branch A1, black 1-pin plug casing, white/grey/
yellow cable.
Disconnect the existing socket contact from slot
0
PIN1, red/green cable on the white 12-pin socket
casing X322B. Connect branch A2, 1-pin socket
contact, red/green cable on the power supply
cable A to the white 12-pin socket casing X322 in
slot PIN1.
Connect the supplied 1-pin black socket casing
on to the disconnected socket contact and
connect it to branch A2, black 1-pin plug casing,
red/green cable. Remove the left tail light.
Issue date: 05.2001
EN/10