Important Information On Installing The Cd Changer In The E38 - BMW 65 12 0 137 910 Installation Instructions Manual

1.

Important information on installing the CD changer in the E38

Only for use in the BMW dealer organisation.
The CD changer may only be installed by a specialist workshop that has the required special
tools and manuals (servicing, repair, diagnostics, etc.).
On cars without a navigation computer and/or without CD changer preparation in the boot
the boot trim on the left must be ordered separately using the Electronic Parts Catalogue
(EPC).
Before installing the power supply cable and the CD changer connection cable, check
whether the required black 3-pin socket casing or the white 3-pin socket casing for the
power supply and the black 6-pin socket casing or the black 10-pin socket casing for the
CD changer connection cable are tied back on the left-hand side of the boot.
In cars with an on-board monitor radio the CD changer connection cable is only installed
in the boot.
When installing cables/leads ensure that they are not kinked or damaged.
Additional cables/leads that you install must be secured with cable ties.
If the specified PIN chambers are occupied, bridges, double crimps or twin-lead terminals
must be used.
Subject to technical modifications
Required tools and equipment
Set of flat screwdrivers
Set of Philips screwdrivers
Angle cutter
1/4 inch socket set
Cable lamp
Retrofit / Installation kit No. 65 12 0 137 910 (others see cover sheet)
Installation Instructions No. 01 29 0 137 927 Issue date: 06.2001
Set of Allen keys
1/2 inch socket set
Set of Torx sockets
BMW disconnection tool
EN/3