Table of Contents
Advertisement
7 .
To install the CD changer (cars without an on-board monitor, without a DSP amplifier and
with Professional radio SA663 after production date 03/01 only)
E1
40
E
X18126
40
B
40
40
12
Retrofit / Installation kit No. 65 12 0 029 649 (others see cover sheet)
Installation Instructions No. 01 29 0 029 574
Lay adapter cable E with control cable B along the
0
audio wiring harness as follows.
Connect branch E1, white 12-pin socket casing on
control cable E, to the new generation radio
connection plug X18126in the centre console.
Lay control cable B from the radio (40) under the
centre console to the left.
B
Lay control cable B between the transmission
tunnel and carpet along the audio wiring harness
under the left seat to the B pillar and along the
door sill to the rear window shelf.
039 0002 B
Thread control cable B through the rubber
0
grommet (40) into the boot to the installation site of
the CD Changer and secure it with cable ties.
F 39 0910 B
Connect the white 12-pin socket casing (E1) on
0
adapter cable E to the new generation radio
connection plug (40).
Connect the new generation radio connection
E1
plug (40) and install the radio.
E
F 39 0911 B
0
Push the expanding nut (12) into the existing hole
(40).
F 39 0912 B
!
The figure shows the boot at the rear left.
Issue date: 05.2001
EN/18
Advertisement
Table of Contents
