Installing The Inner Slides On The System - Sun Microsystems Sun Fire V1280 Installation Manual

1.1.2

Installing the Inner Slides on the System

1. Remove the inner slide from the slide assembly:
a. Press the latch adjacent to the green latch.
b. Pull the inner slide free from the outer slide/rail assembly.
2. Push up on the inner slide so that the locating tab, on the side of the system, clips
over the cutouts in the slide (
The spring tab should engage.
Note – The spring clips must be above the system hooks; the lip on the main body
of the inner slide must engage under and behind the system hook.
3. Secure the inner slide to the system using two 5 x 8 mm screws for each slide.
4. Repeat Step 1 through Step 3 for the second inner slide.
1-4 Sun Fire V1280/Netra 1280 Systems Installation Guide • May 2006
).
FIGURE 1-2