Advertisement
Instructions for kit #71K
□
5. Assemble the Second Floor Wall Sections in the same
manner as steps #1 and #2. Stand back from your house and
check to see that all the Connectors line up.
□
6. Test, trace, paint, and glue the Third Floor Panel in
place, as in step #4 above.
□
1. Assemble the tower room using two Tower Side Panels (the same
as 15
3
/
dividers), two 90° Connectors and a 5" Wall.
4
Trace an Attic Divider and the thickness of a Roof on the 15
that will become the Tower Room Sides. Paint to cover the line, but leave
some un-painted space for glue between the lines.
□
2. Position the Tower Room. Line up the right front 90° connector
with the one below it.
Important: Lay a Divider flat on the third floor flush with the rear edge of
the floor for final positioning of the walls to make the Tower Walls square
with the back edge of the Third Floor.
Test, trace, and paint the 3rd Floor in front of the Tower Room
Roof panel
Tower Side
AtticDivider
Trace
Line up the Connectors
Tower Room Assembly
Exterior paint color
step 6
Let the glue dry
3
/
" Dividers
4
Paint
Walls and Tower (3) page 8
Line up the Connectors
The roof will attach here
Rooftop or Divider
used as a Square
Let the glue dry
Advertisement
