Advertisement
Instructions for kit #71K
Set Up the Walls
□
1. Without glue, set up the 1st floor Walls
and Connectors on the Base Floor (be sure the
square edges of the 135° Connector corners are in
line with the Floor panel, not at 45°, and that the
narrower surface (
/
") of the 90° connector faces
5
8
the front). Adjust the Wall layout until all the
panels are straight up and down: the End Caps line
up with the back of the Floor, and the Walls are
parallel with the floor's edge (not all the same, but
all approximately parallel; when the nosing is at-
tached (pg. 6), the differences will be minimized).
Steps 2 & 3
A
B
D
C
Pro tip: The 13" Divider measures from the rear edge
of the Floor to the inside of wall G. A 15
locates the 135° Connector on wall E. In the porch,
measure 12
15
/
from the right edge of the Floor to the
16
90°Connector on Wall E.
□
2. Trace the inside and the outside of the Wall
layout on the Floor. Paint the floor outside of the
tracing to just cover the line.
□
3. Glue the walls to the Floor following the
inside tracing.
Set the 13" Divider against the back of wall "G" and
a 15
3
/
" Divider against the 135
4
edge of wall E. These Dividers ensure the walls are
straight up-and-down as the glue dries
□
4. Test, trace, and paint the under-side of the
2nd Floor (as in step #2). Glue the Second Floor
panel in place; check the spacing. Use weight
and tape for a tight fit. Make sure the rear edge of
the Side Walls are flush and that everything is set
straight and square. Make sure the house is flat on a
flat surface as the glue dries.
G
F
E
12
15
/
16
3
/
divider
4
o
Connector at the
Let the glue dry
Step #1: Orientation of the Connectors
Critical!
look down
from the top to check
this orientation
135 o Connectors: see that the
square edge is square with the floor
H
Measure 12
15
/
to the edge of the Floor
16
Walls (2) page 7
90 o Connectors: the
5
/
" face
8
is front or back!
15
3
/
4
13" Divider
(not the Nosing)
" Divider
Advertisement
