Advertisement
Instructions for kit #71K
4. Attach the Tower Ceiling, flush at the rear, and
centered side-to-side.
5. Draw shingle lines on the Tower Roof Panels.
6. Glue and Tape together the Tower Roof with the
Front and Rear Panels overlapping the sides. You may
prefer leaving off the Rear Roof for access to that space.
7. Glue the Tower Roof assembly in place on the top
of the Tower Ceiling centered side to side above the walls
of the tower room, and set back the same space from the
Some builders turn the house up-side-
front edge.
down to attach the upper rails in the porch. If that is
your intent, do not attach the Tower Roof yet.
The round window opening faces the front.
The Roof Tops and the round window will be glued in
.
place after shingling
Attach the Edge Nosing
The Edge Nosing covers the edge of the plywood Floors and
overhangs down below the Floors, with the top of the Nos-
ing flush with the floor.
3
Attach the
/
" Nosing to the edges of the Floors, begin-
8
ning with the front of the left bay (M on the illustration)
and work in both directions.
1
Attach the
/
" Nosing to the Tower Ceiling
4
and Roof Tops.
Let the glue dry
Paint the 3rd Floor outside of the Roofs before shingling
Bevels
Nosing (4) page 10
Advertisement
