Using "2006" To Enter The Service Parameters - KERN CPB 3K1M Service Manual

4.2 USING "2006" TO ENTER THE
After the jumper has been placed in the position shown, apply power to the scale.
The display will ask for a code number, "
2006
Enter the number
The displays will show the first parameter
parameters press the
Press the [Tare] key to enter a parameter.
To exit a parameter, press the
The Weight Display window will show the parameter number and the Piece Weight
window will show the word describing the function.
When a parameter is entered by pressing the [Tare] key, the displays will guide you
through the parameter selected and the options available.
The parameters available are:
F1 CAL
F2 rES
F3 CAPA
F4 init ZEro
F5 rE ZEro
F6 SCSivE tArE
F7 Ad Count
F8 ZEro
F9 Pin
F10 LVd ModE
CPB-SH-e-0721
Pn
Pn
when " " is displayed and then press [Tare].
key.
key.
To enter the Calibration
Resolution selection, not valid for CPB-M units
Select Capacity
Initial Zero Range
Re-Zero Range
Successive Tare Enable
Display the A/D counts
Set zero method.
Set new PIN number
Set low voltage detect mode
SERVICE PARAMETERS
" on the Weight Display.
"F1" "CAL"
. To scroll through other
11