Changing Ringer Tones; Repeater Support; Restoring The Base Station To The Factory Settings - Swisscom Aton CL110 Manual

Base station settings
~
Enter the old system PIN and
press
§OK§
is shown as four stars ( **** ).
~
Enter your new system PIN
and press
a
Press and hold (idle status).
Resetting the system PIN
If you have forgotten the system PIN, you
can reset it to the original code 0000 by
resetting the base station to its default set-
tings. This will also reset every other
setting, see "Restoring the base station to
the factory settings"

Changing ringer tones

u
Volume:
You can choose between five volumes
and the "crescendo" ring,
Select "0" to deactivate the base station
ringer.
u
Ringer tones:
You can set a ringer melody for external
¢
calls, page 48.
¢ ¢
Settings
§Menu§
¢
Ringer Volume / Ringer Melody
For how to adjust the settings,
¢
page 48.

Repeater support

With a repeater you can increase the range
and reception strength of your base sta-
tion. You will need to activate repeater
mode. This will terminate any calls that
are in progress at the time.
Precondition: A repeater is registered.
The Eco Mode / Eco Mode Plus is deacti-
vated.
¢ ¢
Settings
§Menu§
¢
Additional Features
Press the display key.
§Yes§
When repeater mode is active, the menu
item is marked with
50
. For security, the PIN
.
§OK§
¢
page 50.
¢
page 48.
¢
Base Audio Settings
Base
¢
Repeater Mode
‰
.
Please note
Repeater support and Eco Mode / Eco
¢
Mode Plus ( page 43) cancel each
other out, i.e. both functions cannot
be used at the same time.
Restoring the base station to the
factory settings
When restoring factory settings:
u
Handsets are de-registered
– When resetting via the menu:
all handsets
– When resetting using the key on
the base station: also all handsets
of other GAP capable devices
u
Individual settings are reset
u
All lists are deleted
u
The system PIN is reset to the original
code 0000
u
Eco Mode plus is activated
Only the date and time are retained.
Resetting the base station via the
menu
¢ ¢
Settings
§Menu§
Press the display key to
§OK§
confirm.
Resetting the base station using a key
on the base station
¤
Disconnect the power cord from the
base station.
¤
Hold down the registration/paging key
¢
( page 2) on the base station while
reconnecting the power cable to the
base station. Press and hold the key
until you hear a confirmation tone.
The base station has now been reset.
¢
Base Base Reset