Changing Your Passcode Type; Programmable Output - Menvier Security SD1+ Operation & Maintenance Manual

Changing Your Passcode Type

The SD1+ requires a passcode to be entered to allow access to the
program menus. This passcode is normally 4 digits (
can be changed to 6 digits (
1234. If the passcode is changed from 4 to 6 digits, the last two
digits of the code will default to (00) i.e. 1234 will now become 1234
00.
Ensure that the SD1+ is initialised and the display is showing
1.
" " (see page 4).
Press 5 and the display will show "
2.
Press [ and the display will show the code type option that is
3.
+
currently programmed i.e. "
Scroll through the other 3 passcode options "
", "
+
key.
Note: Do not use the following passcode types: 4 digits
followed by enter (
enter (
Press [ to accept the option displayed and return to "
4.

Programmable Output

The SD1+ has an output that can be programmed to activate
under certain conditions. These conditions are: active when the
SD1+ has been triggered (
acknowledged (
all numbers and has not been acknowledged (
Ensure that the SD1+ is initialised and the display is showing
1.
" " (see page 4)".
Press 6 and the display will show "
2.
Press [ and the display will show the output type that is currently
3.
+
programmed i.e. "
If required, the other 2 output types "
" " can be scrolled through by pressing the
Press [ to accept the option displayed and return to "
4.
). The default user passcode is
".
" and " ", by pressing the
), or 6 digits followed by
). These are reserved for future use
), active when the SD1+ has been
) and, active when the SD1+ has dialled
".
), but
".
".
).
".
", and
key.
".
SD1+
1
????
READY
2
5
C,TYPE-
3
[
3
4 Digit Code
4, CODE
4 Digit Code + ENT
B
4+E, CODE
B 6 Digit Code
6, CODE
B 6 Digit Code + ENT
6+E, CODE
4
[
READY
SD1+
1
????
READY
2
6
OUTPUT-
3
[
3
Has Been Triggered
ACTIVE
B Has Been Acknowledged
SUCCESS
B
Failed to Communicate
FAILED
4
[
READY
5