Programming: Telephone Numbers; Ent; Or 0-D - Menvier Security SD1+ Operation & Maintenance Manual

Programming: Telephone Numbers

The SD1+ stores up to four telephone numbers, with a maximum of 24 digits each. Permission from
the person(s) being called must be obtained before storing their telephone number. The SD1+
must NOT be used to call the Police via the Emergency Services telephone numbers.
The following example shows how to program telephone number 1 as 0181 234 5678.
Ensure that the SD1+ is initialised and the display is showing
1.
" " (see page 4).
Press [, the unit will display "
2.
+
Press 1 for telephone number 1.
3.
+
1 to 4 will select numbers 1, 2, 3 or 4.
0 to D selects phrases 0, A, B, C or D (see page 12).
The display will alternate between telephone No. 1 and the
4.
+
current number (Blank if it has not been programmed).
If a telephone number is already programmed, this may
be deleted by pressing the
Type in the first phone number 0181 234 5678.
5.
If a mistake is made whilst entering the number, press A to
6.
+
move the cursor back, re-enter the digit and press C.
Pressing
Finish typing in the telephone number and press [.
7.
Repeat for telephone number 2, 3 & 4 as required.
8.
When finished, press ] to return to the ready prompt.
9.
+
In order for the SD1+ to comply with BABT regulations, the
unit must NOT have any telephone numbers programmed
+
the same.
The SD1+ must NOT be used to call the Police via the
Emergency Services telephone numbers.
8
will move the cursor forward again.
".
key.
1
SD1+
????
READY
2
[

ENT 1-4

OR 0-D

3
1
4 3
TEL NO 1
BLANK
5
018153
018153*
6
AA
0181 3 *
2C
018123*
7
45678[
8
ENT 1-4
OR 0-D
9
]
READY