Recording Messages - Menvier Security SD1+ Operation & Maintenance Manual

Recording Messages

The SD1+ can record up to four phrases A, B, C, D and a common phrase 0. These phrases can be
up to forty seconds in total. The five phrases are used to form four messages A, B, C and D. Phrase 0
is normally used to store the name and address of the premises, whereas phrases A, B, C or D are
used to store the type of alarm condition. It is also advisable to include the instruction to press the
number "8" button on the telephone, at the end of the message e.g.
Phrase 0: "This Is Mr Smith, at 10 The Strand, East Fincham"
l
Phrase A: "The alarm has been activated, please press eight to acknowledge this call".
l
Ensure that the SD1+ is initialised and the display is showing
1.
" " (see page 4).
Press [ and the unit will display "
2.
+
Press 0 for phrase 0.
3.
+
0 to D will select phrases 0, A, B, C or D.
1 to 4 selects numbers 1, 2, 3 or 4 (see pages 8-11).
+
The display will show "
4.
+
Stand back about 6-8 inches from the unit.
Before you record phrases, it is advisable to prepare
them by writing them down first.
When ready, press the [ key to start recording, and speak
5.
+
clearly into the unit.
+
The display will show the remaining recording time.
When re-recording a phrase, if the duration of the old
phrase was previously 10 seconds, then the new phrase
must be the same length.
+
To end recording at any time press
6.
The unit will also stop recording when the time runs out.
Repeat for phrases A, B, C & D as required.
7.
When finished, press ] to return to the ready prompt.
8.
12
".
".
.
1
SD1+
????
READY
2
[
ENT 1-4
OR 0-D
3
0
4 3
RECORD
PHRASE 0
5
[
REC - 40
This is Mr Smith,
at 10 The Strand,
East Fincham.
REC - 32
6
]
7
ENT 1-4
OR 0-D
8
]
READY