Programming: Initialising The Sd1; Changing Your Passcode - Menvier Security SD1+ Operation & Maintenance Manual

Programming: Initialising The SD1+

When you power up the SD1+ for the first time, a factory restart is
required. This involves shorting out the factory restart pins (JP2) whilst
applying power to the unit (please refer to the installation
instructions for details). The display will show "
indicates that the memory is blank (i.e., all telephone numbers and
messages are not programmed). Once it is programmed, "
displayed instead. To gain access to the programming menus, the
passcode must be entered (Default 1234).
When the unit is powered up for the very first time, the display
1.
+
shows "
When programmed, the display shows "
Enter the default user code 1234 to initialise the unit ready
2.
for programming.
When initialised the display shows "
3.
+
programmed and tested.
To exit from the main menu press
operated for 1 minute, it will revert back to the "
" message (or "

Changing Your Passcode

The SD1+ requires a passcode to be entered to allow access to the
program menus, this passcode can also be used to abort the
operation of the unit when triggered (see page 6). The passcode is
normally four digits, but can be changed to six (see page 5). The
default passcode is 1234 and can also be changed as required.
Ensure that the SD1+ is initialised and the display is showing
1.
" " (see page 4).
Press 4 and the display will show "
2.
Press [ and the display will show "
3.
Enter your new passcode e.g. 2580.
4.
Press [ to accept the new code and return to "
5.
4
".
", the unit can now be
", fig 2).
".
", this
" is
" (fig 2).
, if the unit is not
".
".
1 PLEASE
RECORD
2
????
3
READY
]
PLEASE
RECORD
Fig 1
SD1+
1
2
????
3
READY
]
SD1+
Fig 2
SD1+
1
????
READY
2
4
NEWCODE-
3
[
----
4
2580
2580
5
[
READY