Candis Display Instrument (O) - Jungheinrich ERE 120 Operating Instructions Manual

7.7

CanDis Display Instrument (o)

The instrument indicates:
Battery charge display (on board charger
64
only)
65 LED bars for battery charge status
"Warning" symbol (yellow),
66
Battery charge recommended
"Stop" symbol (red); lift cutout,
67
Battery charge essential
No symbol when battery type set to normal
or enhanced performance wet cell battery
"T" symbol appears steadily during
operation when battery type set to
68
maintenance-free
"T" symbol appears flashing during
operation when battery type set to special,
such as XFC
6 digit LCD display:
– Service hours
69
– Settings entry and changes
– Event messages
Charge status display
The charge status is shown through eight LED bars.
Eight lit LED bars correspond to a fully charged battery. One lit LED bar corresponds
to an almost discharged battery.
When the "Attention" symbol (66) starts to flash, it is advisable to charge the battery.
If the "Attention" symbol (66) is lit steadily, the battery must be charged.
If the "Stop" symbol (67) is lit steadily, the battery must be charged immediately. If
activated, the discharge monitor function is applied in this case, see "Discharge
monitor function" on page 126.
Z
The point at which the "Attention" (66) and "Stop" (67) symbols start to light up
differs depending on the battery type.
64
66
68
65
67
69
125