Capi - Gigaset hybird 120 Edition Manual

6 Terminals
Field
Transmit Charges
Pulses
FXS Ringing Fre-
quency
Flash Time for DTMF
Dialling

6.2.4 CAPI

If your device supports CAPI, you configure the connected CAPI terminals in the menu
Terminals->Other phones->CAPI. For example, you perform assignment of a configured
internal number.
6.2.4.1 Edit or New
Choose the
The Terminals->Other phones->CAPI->New menu consists of the following fields:
Fields in the menu Basic Settings
130
Description
Select whether the system shall generate charge pulses for the
terminal from the ISDN network charge information. For this
purpose, you can define the charge impulse at 12 kHz or 16
kHz.
Possible values:
• : Charge information from the ISDN network is not trans-
mitted.
•
•
Call signalling in analogue terminals occurs by configuring a
call switching voltage at the called analogue connections. This
call switching voltage is converted into a specific ring tone by
the analogue terminal. In the system, for the analogue connec-
tions you can set a call switching voltage with a frequency of
or
The default value is
When operating analogue terminals with the multifrequency
code dialling method, you can set the flashtime that the system
detects as maximum flash length. If the terminal flash is longer
than the defined period, "replaced receiver" is detected.
Values from
sible.
icon to edit existing entries. Select the New button to add CAPI terminals.
.
Hz.
(standard value) to
Gigaset Communications GmbH
are pos-
hybird 120 Gigaset Edition