Clean - Panasonic ES-TLVK6 Operating Instructions Manual

►Notes
• If you press the power switch for more than 2 seconds, the sonic
vibration cleaning mode is activated. (See page 15.)
You cannot shave in this mode.
• Do not place your fingers on the power switch while using the
shaver. This may cause the shaver to switch the mode or turn off.
Place your fingers on the finger rest while using the shaver.
• We recommend using the shaver in an ambient temperature range of
5 – 35 °C. If used outside this range, the appliance may stop operating.
Reading lamps when using
During use
The used time and remaining
battery capacity are shown and
then turn off after 5 seconds.
• The shown time returns to
[0'00"] after 10 minutes.
• The charge status lamp (
glows when using cord shaving.
When the battery capacity is low
"10%" appears and "
• You can shave 1 to 2 times after "10%" appears. (This will differ
depending on usage.)
• A full charge will supply enough power for approx. 14 shaves of
3 minutes each. (This will differ depending on usage.)
ES-TLVK6_ASIA.indb 13
After use
The lamps will light up and
then turn off after 8 seconds.
)
" blinks.

Clean

Cleaning using the self-cleaning recharger
►Preparing the self-cleaning recharger
Remove the shaver and the appliance plug from the self-cleaning
recharger.
1
1
Place the self-cleaning recharger on a hard, flat
surface.
• When the self-cleaning recharger is lifted, or on the soft
surface such as carpets, the lock release lever will not fit in
the recharger properly. In that case, the cleaning liquid unit
cannot be removed.
2
2
Press the cleaning
liquid unit removal
button and remove
1
the cleaning liquid
unit.
3
3
Wash away the old cleaning liquid and beard
trimmings and then rinse the cleaning liquid unit.
• After washing, be sure to attach the cleaning liquid filter.
4
4
Pour tap water and
detergent into the
cleaning liquid unit.
• Do not let the water rise
above the maximum water
line. This may cause the
cleaning liquid to spill.
2
1 2
13
2015/06/08 13:23:04