Troubleshooting - Panasonic ES-TLVK6 Operating Instructions Manual

►When the water does not drain from the cleaning
tray
Beard trimmings may clog the drain at the
bottom of the cleaning tray.
In this case, you cannot clean or dry the shaver.
Push the beard trimmings down through the
drain with a toothpick etc.

Troubleshooting

►Self-cleaning recharger
Problem
The blade has not been
thoroughly washed.
The STATUS lamp glows.
18
ES-TLVK6_ASIA.indb 18
Action
If the shaver is not cleaned for
more than 2 weeks, first clean
with the cleaning brush to remove
beard trimmings. (See page 16.)
Do not add detergent and water
except when replacing the
cleaning liquid.
Doing so may deteriorate the
cleaning function. (See page 14.)
After cleaning, oil-like droplets
may remain on the outside of the
foil frame. This is the lubricating
component of the cleaning liquid
and does not indicate a problem.
You may wipe it off with a soft
cloth.
See page 21.
Problem
Check that the AC adaptor is
connected to the self-cleaning
recharger, and that the recharger
is plugged in to a household
outlet. (See page 10.)
Confirm that the shaver is
properly attached to the self-
cleaning recharger.
The mode does not start.
(See page 10.)
The Clean or Dry operation may
not function under extreme low
temperatures (approx. 0 °C or
lower).
Check if the STATUS lamp glows.
(See page 21.)
Remove any waste, etc. that has
accumulated in the drain at the
bottom of the cleaning tray.
(See this page.)
Cleaning liquid has
accumulated in the
If you use the self-cleaning
cleaning tray.
recharger when the shaver is wet
or when soap or shaving gel is on
the shaver, cleaning liquid may
accumulate in the cleaning tray.
Place the self-cleaning recharger
on a hard, flat surface.
When the self-cleaning recharger
The cleaning liquid unit is lifted, or on the soft surface such
cannot be removed. as carpets, the lock release lever
will not fit in the recharger properly.
In that case, the cleaning liquid
unit cannot be removed.
Action
2015/06/08 13:23:05