Panasonic ES-TLVK6 Operating Instructions Manual page 14

5
5
Attach the cleaning liquid unit.
• Immediately wipe up any cleaning liquid
that has been spilt.
Be careful not to drop cleaning liquid
onto leather products or wooden floors
as it may cause discoloration.
6
6
Press the top of the self-
cleaning recharger down and
securely attach until it clicks.
►Notes
• The water and detergent will mix after cleaning begins, making
cleaning liquid.
• When the cleaning liquid level has dropped, the LOW lamp will
glow to indicate the cleaning liquid should be replaced.
• After the LOW lamp glows, you can clean the shaver with the
self-cleaning recharger for approximately 7 days.
• Replace the cleaning liquid when the STATUS lamp glows.
• When replaced, the cleaning liquid will last for approximately
30 days if used once per day. (This will differ depending on beard
thickness and the ambient temperature.)
• Use the detergent within approximately 6 months after opening
the package. When 6 months have passed, discard the cleaning
liquid, and then pour new water and detergent into the cleaning
liquid unit.
• Replace the water and detergent at the same time.
Otherwise the cleaning function may deteriorate.
• Only use self-cleaning recharger detergent for Panasonic shavers.
14
ES-TLVK6_ASIA.indb 14
►Cleaning the shaver
Remove any soap or water on the shaver if it has been washed
with hand soap or any other detergent.
1
1
Insert the appliance plug
into the self-cleaning
recharger.
2
2
Remove the protective cap
and then attach the shaver.
3
3
Plug in the adaptor into a
household outlet.
• Turn the shaver off before attaching.
• Wipe off any water droplets on the main body rear terminals.
• Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
4
4
Press the SELECT button to select the mode.
• The "Charge" mode starts when attaching the shaver.
• Each time you press the SELECT button, the mode changes
from "Clean/Dry/Charge" "Dry/Charge"
• The modes start approximately 6 seconds after they are
selected.
• The mode will be aborted if the power is cut off. In this case,
perform the mode again from the beginning.
• Do not press the cleaning liquid unit removal button as the
cleaning liquid may spill causing a malfunction.
2
3
1
"Charge".
2015/06/08 13:23:04